About Items

ABHERI JEWELRY uses platinum (PT900) and gold (K18 gold).

Gold can be selected from three colors of yellow gold (yg) and champagne gold (ch).

White color is only available in Pt; K18wg (white gold) is not available except for some metal fittings.

About ring size

Ring sizes are available in units of #0.5. You can only specify the size in units of #1 on the order screen,but if you wish, please enter the desired size in units of #0.5 in the remarks column when ordering. 

For OVER-SIZE such as over #20 (Large/Medium), or over #18 (Small/Other) , ORDER or RESIZE will be charged a special fee.

* How to measure ring size
  Since the size and comfort of the ring fit depending on the design, we recommend that you measure at a jewelry store near you.
  Alternatively, you can refer to the following contents to determine the ring size. 

1. Search from the inner circumference of the ring. Measure around the thickest part of the finger you want to wear with a string.
2. Check from the ring inner diameter. Measure the diameter (inner diameter) of the ring you have.
   

  Then determine the size from the table below. Please choose the closest value above the measured value.

Ring Sizing Chart →

* *For reference only.

■The ring in chain type made you can adjust the size by sliding the chain and changing the length.

■The flexibility gives you the freedom to wear in any fingers you wish to.

■As the size range that can be worn varies depending on the design, please check the details page of each product.

How to use the chain ring

* There are two types of slide fittings, spherical and tubular.

■Silicon built into the slide metal fittings serves as a stopper.

■Hold it delicately with care from behind with your fingers and slide it so that you can press it slowly to adjust.

■Be careful not to pinch and pull only the tip of the chain, DO NOT apply excessive force in the opposite direction, as this may break the chain.

■When you are going to wear it, before put it on your finger, please spread the ring to the maximum size first, so you can adjust the size to wear it smoothly.

■You can slide the slide fitting along your finger to loosen for taking off it.

The length of necklace and bracelet chains can be adjusted by sliding metal fittings.
If you want to change the length of the chain, please inform us when placing the order.
There is no extra charge for decreasing the length of the chain. However, when extending the length, we will inform you estimated extra cost.

How to slide

* There are two types of slide fittings, spherical and tubular.

Silicon built into the slide metal fittings serves as a stopper.
Grab it from behind with your fingers and slide it so that you can press it slowly to adjust.
Be careful not to pinch and pull only the tip of the chain, or apply excessive force in the opposite direction, as this may break the chain.

*We accept changes to clip-on earring from stud earrings. Please contact us for more details.
* Some hardware may not be available depending on the design.

■ American earrings
You can enjoy the swaying design with the motif hanging under the earlobe.

■ Hoop earrings
Not only can you enjoy the dangling of the hoop metal fittings.
Since it is a metal fitting that stays firmly in the spring.

■ Earrings
K18 pierced earrings are made only from yellow gold.